BMW X5 4.8i 2008 - Manual (Page 68)

Driving
66
Releasing
1. Slide back the cover of the cup holder and
remove the floor mat on the bar between
the cup holders, arrow
1.
2. Open the cover in the bottom of the cup
holder with the releasing tool from the
onboard tool kit, page
247 , refer to arrow 2.
3. If necessary, unlock the lock * with the inte-
grated key of the remote control, refer to
page
28 , and remove it.
4. Insert the releasing tool into the opening,
arrow
3.
5. Turn the releasing tool as far as possible,
arrow
4, and then press downward and
leave it in. The transmission lock is
released.
Engage the transmission lock after park-
ing the vehicle at its destination. Other-
wise there is a danger of the vehicle rolling. <
Locking
1. Pull out the releasing tool.
The transmission lock is engaged again.
2. If necessary, insert the lock * and lock it.
3. Close the cover in the bottom of the cup
holder and lay in the mat again.
4. Close the cover of the cup holder and stow
the releasing tool.
Information on jump starting and towing, from
page
256 .
Turn signals/headlamp
flasher/high beams
1 High beams
2 Headlamp flasher
3 Turn signals
Using turn signals
Press the lever beyond the resistance point.
To switch off manually, press the lever up to the
resistance point.
Atypically rapid flashing of the indicator
lamp indicates that a turn signal bulb
needs to be replaced. <
Online Edition for Part no. 01 41 0 014 248 - © 08/07 BMW AG