BMW X5 3.0si SAV 2007 - Manual (Page 118)

Practical interi
or
acc
ess
orie
s
116
Cargo bay
Roll-up cover
Pull out the roll-up cover and hook it into the
brackets.
Do not place heavy or hard objects on the
roll-up cover. If you do so, they may
already pose a danger to vehicle occupants dur-
ing braking or evasive maneuvers.
Do not allow the roll-up cover to snap back, oth-
erwise it can be damaged.
<
Removing
1. Unlock the case with the button, arrow 1.
2. Swing the case somewhat to the left,
arrow
2, and remove.
Installing
When installing, proceed in the opposite order
of removal.
1. Lay on the case on the left-hand side and
push it forward, arrow
1.
2. Swing the case toward the inside, refer to
arrow
2.
3. Push the case forward at the ends until it
engages in the two side brackets.
4. Check whether the case is properly locked
in place by pulling it with a sudden move-
ment.
Separation net*
Hooking in separation net
Pull the separation net out of the case by the
loop. Grasp the rod on both sides and insert it in
the brackets, arrow
1. This is best carried out
from the rear seat.
Letting down separation net
When you no longer require the separation net,
grasp the rod on both sides and remove it from
the brackets, arrow
2. Then slowly allow the
separation net to glide into the case.
Online Edition for Part no. 01 41 0 012 501 - © 08/06 BMW AG