BMW 650i Coupe 2006 - Manual (Page 200)

M
o
bi
lity
199
Re
fe
re
n
c
e
At
a
g
la
n
c
e
Co
n
tr
o
ls
D
riv
in
g ti
ps
C
o
m
m
uni
ca
ti
o
n
s
Na
v
iga
ti
on
En
te
rt
a
in
m
e
n
t
4. Turn the bulb holder to the left and remove,
refer to arrow.
5. Remove and replace the bulb.
Sidemarker
Bulb 5 watts, WY5W ST
The bulb can be replaced via a cover at the front
of the wheel well, refer to the description for
turn signal lamp 2.
1. The bulb holder of the sidemarker lamp is
located toward the outside of the vehicle
next to the bulb holder of turn signal lamp 2.
2. Turn the bulb holder to the left and remove.
3. Remove and replace the bulb.
Side turn signals
Bulb 5 watts, WY 5 W
1. Press against the front edge of the lamp
with the tip of your finger, then push it to the
rear, release the snap connection at the
front and take it off the trim strip.
2. Turn the bulb holder to the left by 90 5 and
remove.
3. Remove and replace the bulb.
Tail lamps
The roadside parking, rear and brake
lamps are LEDs. The backup lamps are
equipped with long-life bulbs. Please contact a
BMW center in case of a malfunction.
<
1 Turn signals
2 Roadside parking, rear and brake lamp
3 Backup lamp
4 Reflector
Rear turn signals
Bulb 21 watts, PY 21 W
The illustration shows the recess on the left
side of the luggage compartment.
1. Remove the cover.
2. Unclip the bulb holder and remove.
3. Apply gentle pressure to the bulb while
turning it to the left for removal and replace-
ment.
Online Edition for Part-No. 01 41 0 159 709 © 09/05 BMW AG