BMW X3 2.5i SAV 2005 - Manual (Page 69)

Practical interi
or
acc
ess
orie
s
68
Do not place heavy and hard objects on
the cover. If you do so, they could endan-
ger occupants during braking maneuvers. Do
not allow the cover to snap back into place, as
otherwise it could be damaged.
<
Removal
1. Press the side buttons, refer to arrow 1.
2. Pull the cassette towards the rear, refer to
arrow
2.
Installation
Push the cassette forward into the two side
holders until it locks in place.
Stowing* when rear seat back is folded
down
Holders for the cassette are fitted to the backs
of the rear seat backs, refer to arrows
1.
Guide in the cassette from the right side until it
locks in place, refer to arrow
2. Here, the cargo
area cover must always point in the direction of
travel and the loop of the partition net must
point upward.
You can pull out the partition net and insert it in
the holders in the roof area above.
Partition net*
Hooking partition net into place
Pull the partition net out of the cassette by the
strap. Push together the bar on both sides, refer
to arrows
1, and insert in the brackets. Then
press the bar all the way upward in the middle,
refer to arrow
2, so that it engages in the brack-
ets.
Letting down partition net
Grasp bar on one side on the partition net, press
upward and push together, then release from
the brackets.
Do not allow the partition net to snap back
into place, as otherwise there is a danger
of injury and the partition net could be dam-
aged.
<
Behind side trim panel
Press the button to open.
Online Edition for Part-No. 01 41 0 158 448 - © 09/04 BMW AG