BMW X3 2.5i SAV 2005 - Manual (Page 64)

Re
fe
re
n
c
e
A
t a
g
lanc
e
Co
n
tr
o
ls
D
riv
in
g tip
s
M
o
b
ilit
y
63
The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.
You can use the system when the engine is run-
ning or when the ignition is switched on.
If the system cannot be operated after
repeated programming, check whether
the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the
instructions of the original hand-held transmit-
ter or press and hold down the programmed
memory button
1 of the integrated universal
remote control. If the indicator lamp 2 on the
integrated universal remote control flashes rap-
idly for a short time then lights up for approx.
2 seconds, this indicates that the original hand-
held transmitter uses an alternating-code sys-
tem. In the case of an alternating-code system,
program the memory buttons
1 as described at
the section on alternating-code transmitters. <
Alternating-code transmitters
Consult the operating instructions of the unit
you wish to set when programming the univer-
sal remote control. You will find information
there on the possibilities for synchronization.
When programming hand-held transmitters
that employ an alternating code, please follow
these additional instructions:
Programming will be easier with the aid of
a second person.
<
1. Park your vehicle within the range of the
remote-controlled equipment.
2. Program the integrated universal remote
control as described above at Fixed-code
hand-held transmitters.
3. Locate the button at the receiver of the
equipment to be set, e.g. on the drive.
4. Press the button on the receiver of the
device you want to set up. After step 4, you
have approx. 30 seconds for step 5.
5. Press the programmed memory button 1
of the integrated universal remote control
three times.
The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.
If you have questions, please contact your
BMW Sports Activity Vehicle Center.
<
Clearing memory buttons
Press both outer buttons 1 for approx. 20 sec-
onds until the indicator lamp 2 starts to flash:
all of the memory buttons are cleared.
The memory of individual memory buttons
1
cannot be cleared.
Cup holders
Front
Depending on your optional equipment, the
center console contains either one or two cup
holders.
Passenger side*
The cup holder for the front passenger is
located beneath the air/heating vent.
1. Press the trim piece below the air/heating
vent, arrow.
2. Insert cup.
Online Edition for Part-No. 01 41 0 158 448 - © 09/04 BMW AG