Opening and closing – BMW 760i Sedan 2004 User Manual
Page 42
Opening and closing
40
>
To a change in the vehicle's tilt if some-
one attempts to steal the wheels or tow
the vehicle
>
To interruption of battery voltage.
The system responds to unauthorized vehi-
cle entry and attempted theft by simulta-
neously activating:
>
An acoustic alarm, which lasts for a
period of approx. 30 seconds
>
The hazard warning flashers for approx.
five minutes
>
The high beams, which flash on and off
in the same rhythm.
Arming and disarming the alarm
system
When you lock or unlock the vehicle, either
with the remote control unit or at the door
lock, the alarm system is armed or dis-
armed at the same time.
The system indicates that it has been cor-
rectly armed by switching on the hazard
warning flashers for a single cycle and by
emitting an acoustic signal.
You can have different acknowledg-
ment signals set to confirm arming
and disarming.
<
You can also open the luggage compart-
ment lid with the system armed using
button 3
on the remote control, refer to
. When you close the lid, the sys-
tem is rearmed.
Pressing the Panic mode button for a
longer period triggers the alarm, refer
<
To deactivate the alarm
>
unlock the vehicle using the remote
control, refer to page
>
insert the remote control all the way into
the ignition lock, engaging the detent.
Indicator lamp displays
>
The indicator lamp below the interior
rearview mirror flashes continuously:
the system is armed
>
The indicator lamp flashes when the
system is armed: door(s), the hood or
luggage compartment lid are not com-
pletely closed. Even if you do not close
the alerted area, the system begins to
monitor the remaining areas, and the
indicator lamp flashes continuously
after 10 seconds. However, the interior
motion sensor is not activated
>
The indicator lamp goes out when the
system is disarmed: no manipulation
or attempted intrusions have been
detected in the period since the system
was armed
>
The indicator lamp flashes when you
disarm the system before the remote
control unit is inserted in the ignition
lock, but for no more than roughly
5 minutes: an attempted entry has been
detected in the period since the system
was armed.
Following triggering of an alarm, the indica-
tor lamp will flash continuously.
Avoiding unintentional alarms
The tilt alarm sensor and interior motion
sensor may be switched off at the same
time. You can do this to prevent a false
alarm from being triggered in garages with
elevator ramps, for instance, or when the
vehicle is transported by trailer or train:
Lock, i.e. arm twice; press button 2
on the remote control twice in succession,
refer to page
.
The indicator lamp lights up briefly and
Online Edition for Part No. 01 41 0 157 670 - © 08/03 BMW AG