Rolling code programming, Driver controls – FORD 2012 F-150 Raptor v.1 User Manual

Page 117

Advertising
background image

Types of garage door openers (rolling code and fixed code)

The Car2U

௡ Home Automation System may be programmed to operate

rolling code and fixed code garage door openers.
• Rolling code garage door openers were produced after 1996 and are

code protected. Rolling code means the coded signal is changed every
time your remote control garage door opener is used.

• Fixed code garage door openers were produced prior to 1996. Fixed

code uses the same coded signal every time. It is manually
programmed by setting DIP switches for a unique personal code.

If you do not know if your garage
door opener is a rolling code or
fixed code device, open your garage
door opener’s remote control battery
cover. If a panel of DIP switches is
present your garage door opener is
a fixed code device. If not, your
garage door opener is a rolling code
device.

Note: Programming the Car2U

௡ system to a community gate will require

a unique set of instructions depending on the gate system model.
Contact the Car2U

௡ help line at 1-866-572-2728 to program your Car2U௡

system.

Note: Accidentally entering the program mode may override previously
programmed buttons. This can happen by pressing and releasing the
outer two buttons, or all three buttons, simultaneously. If this happens,
do not press any button until the module times out after approximately
2.5 seconds and resets to normal mode. When time-out occurs, all three
LEDs will flash rapidly for a few seconds then turn off. Any settings
should remain as previously set.

Rolling code programming

Note: Programming the rolling code garage door opener involves
time-sensitive actions. Read the entire procedure prior to beginning so
you will know which actions are time-sensitive. If you do not follow the
time-sensitive actions, the device will time out and you will have to
repeat the procedure.

Note: Do not program the Car2U

௡ system with the vehicle in the garage.

Make sure that your key is on and engine off while programming the
transmitter.

1

2 3 4

5

6

7

8

9 10 11 12

CTS 206-12 T124

O

N

Driver Controls

117

2012 F-150 (f12)
Owners Guide, 1st Printing
USA
(fus)

Advertising
This manual is related to the following products: