Compass calibration adjustment, Auxiliary power point (12v dc), Driver controls – FORD 2012 F-150 Raptor v.1 User Manual

Page 100

Advertising
background image

Compass calibration adjustment

Perform compass calibration in an open area free from steel structures
and high voltage lines. For optimum calibration, turn off all electrical
accessories (heater/air conditioning, wipers, etc.) and make sure all
vehicle doors are shut.

1. Start the vehicle.

2. To calibrate, press and hold the 7
and 9 radio preset buttons together
for approximately 10 seconds until
CAL appears. Release the buttons.

3. Slowly drive the vehicle in a
circle (less than 3 mph [5 km/h])
until the CAL display changes to the
direction value (N, S, E, W, etc.). It
may take up to five circles to
complete calibration.

4. The compass is now calibrated.

AUXILIARY POWER POINT (12V DC)

Power outlets are designed for accessory plugs only. Do not insert
any other object in the power outlet as this will damage the
outlet and blow the fuse. Do not hang any type of accessory or
accessory bracket from the plug. Improper use of the power
outlet can cause damage not covered by your warranty.

Auxiliary power points can be found in the following locations:
• On the instrument panel
• Inside the center console storage area (if equipped)
• On the rear of the center console (if equipped) accessible from the

rear seat

Always keep the power point caps closed when not being used.

Do not use the power point for operating the cigarette lighter element (if
equipped).

Note: Do not plug optional electrical accessories into the cigarette lighter
socket (if equipped). Improper use of the lighter can cause damage not
covered by your warranty, and can result in fire or serious injury.

Driver Controls

100

2012 F-150 (f12)
Owners Guide, 1st Printing
USA
(fus)

Advertising
This manual is related to the following products: