Safety belt extension assembly, Safety belt warning light and indicator chime, Conditions of operation – FORD 2011 Escape Hybrid v.2 User Manual

Page 136: Seating and safety restraints

Advertising
background image

WARNING: The driver and front passenger safety belt system
(including retractors, buckles and height adjusters) must be

replaced if the vehicle is involved in a collision that results in
deployment of front airbags, seat-mounted side airbags and Safety
Canopy

௡ System and safety belt pretensioners.

WARNING: Failure to replace the safety belt assembly under
the above conditions could result in severe personal injuries in

the event of a collision.

Safety belt extension assembly

If the safety belt is too short when fully extended, a 9 inch (23 cm) or
12 inch (31 cm) safety belt extension assembly can be added (part
numbers 611C22–A and 611C22–B respectively). These assemblies can
be obtained from an authorized dealer.

Use only extensions manufactured by the same supplier as the safety
belt. Manufacturer identification is located at the end of the webbing on
the label. Also, use the safety belt extension only if the safety belt is too
short for you when fully extended.

WARNING: Do not use extensions to change the fit of the
shoulder belt across the torso.

Safety belt warning light and indicator chime

The safety belt warning light illuminates in the instrument cluster and a
chime sounds to remind the occupants to fasten their safety belts.

Conditions of operation

If...

Then...

The driver’s safety belt is not
buckled before the ignition
switch is turned to the on
position...

The safety belt warning light
illuminates 1 minute and the warning
chime sounds 6 seconds.

The driver’s safety belt is
buckled while the indicator
light is illuminated and the
warning chime is sounding...

The safety belt warning light and
warning chime turn off.

Seating and Safety Restraints

136

2011 Escape Hybrid (ehv)
Owners Guide, 2nd Printing
USA
(fus)

Advertising