FORD 2011 Explorer v.2 - Manual (Page 48)

NO KEY DETECTED (if equipped) — Displayed if the Intelligent
Access Key is not detected by the system in the following three
scenarios:
• When the start/stop button is pressed in an attempt to either start the
engine or cycle through the ignition states.
• When the engine is running and a door is opened then closed.
•When the vehicle’s speed exceeds 10 mph (16 km/h) for the first time
after starting. Refer to Push button start system in the Driving chapter
for more information.
PRESS BRAKE TO START (if equipped) — Displayed when the
start/stop button is pressed without the brake pedal being applied. This
is a reminder that the brake pedal must be applied when the start/stop
button is pressed in order to start the engine.
RESTART NOW OR KEY IS NEEDED (if equipped) — Displayed
when the start/stop button is pressed to shut off the engine and a
Intelligent Access Key is not detected inside the vehicle. Refer to Push
button start system in the Driving chapter for more information.
SPEED LIMITED TO 130 KM/H — Displayed when starting the
vehicle and MyKey
௡ is in use and the MyKey speed limit is on. Refer to
MyKey
௡ in the Locks and Security chapter for more information.
SPEED LIMITED TO 80 MPH — Displayed when starting the vehicle
and MyKey
௡ is in use and the MyKey speed limit is on. Refer to MyKey௡
in the Locks and Security chapter for more information.
STARTING SYSTEM FAULT — This message is displayed when there
is a problem with your vehicle’s starting security system; your vehicle
will not be able to start. See your authorized dealer for service.
VEHICLE AT TOP SPEED OF MYKEY SETTING — Displayed when
a MyKey
௡ is in use and the MyKey speed limit is on and the vehicle
speed is 80 mph (130 km/h). Refer to MyKey
௡ in the Locks and
Security chapter for more information.
VEHICLE NEAR MYKEY TOP SPEED — Displayed when a MyKey
௡
is in use and the MyKey speed limit is on and the vehicle speed is
approaching 80 mph (130 km/h). Refer to MyKey
௡ in the Locks and
Security chapter for more information.
ADAPTIVE CRUISE MALFUNCTION (if equipped) — Displayed
when a radar malfunction is preventing the ACC from engaging.
ADAPTIVE CRUISE NOT AVAILABLE (if equipped) — Displayed
when conditions exist such that the adaptive cruise cannot function
properly.
Instrument Cluster
48
2011 Explorer (exp)
Owners Guide, 3rd Printing
USA (fus)