Steering, Driving – FORD 2007 F-550 v.1 User Manual

Page 177

Advertising
background image

Note: If your vehicle is equipped with a manual transmission, the engine
may be required to run while power accessories operate and the parking
brake is set. It is recommended that wheel chocks be used during this
operation.

If you’re parking your vehicle on a grade or with a trailer, press and hold
the brake pedal down, then set the parking brake. There may be a little
vehicle movement as the parking brake sets to hold the vehicle’s weight.
This is normal and should be no reason for concern. If needed, press and
hold the service brake pedal down, then try reapplying the parking
brake. Chock the wheels if required. If the parking brake cannot hold the
weight of the vehicle, the parking brake may need to be serviced or the
vehicle may be overloaded.

STEERING

To help prevent damage to the power steering system:
• Never hold the steering wheel at its furthest turning points (until it

stops) for more than three to five seconds when the engine is running.

• Do not operate the vehicle with a low power steering pump fluid level

(below the FULL COLD mark on the dipstick).

• Some noise is normal during operation. If excessive, check for low

power steering pump fluid level before seeking service by your dealer.

• Heavy or uneven efforts may be caused by low power steering fluid.

Check for low power steering pump fluid level before seeking service
by your dealer.

• Do not fill the power steering pump reservoir above the FULL HOT

mark on the dipstick, as this may result in leaks from the reservoir.

If the power steering system breaks down (or if the engine is turned
off), you can steer the vehicle manually, but it takes more effort.

If the steering wanders or pulls, check for:
• an improperly inflated tire
• uneven tire wear
• loose or worn suspension components
• loose or worn steering components
• improper steering alignment
If any steering components are serviced or replaced, install new
fasteners (many are coated with thread adhesive or have prevailing
torque features which may not be re-used). Never re-use a bolt or nut.
Torque fasteners to specifications in Workshop Manual.

2007 F-250/350/450/550 (f23)
Owners Guide (post-2002-fmt)
USA
(fus)

Driving

177

Advertising
This manual is related to the following products: