FORD 2006 Crown Victoria v.2 - Manual (Page 254)

Fluid Ford Part Name Capacity
Fuel tank N/A 19.0 gallons (71.9L)
Rear axle lubricant 5 Motorcraft SAE
80W-90 Premium Rear
Axle Lubricant
5.0 pints (2.4L) 7
Windshield washer
fluid Motorcraft Premium
Windshield Washer
Concentrate
Fill to line on reservoir
1 Use only brake fluids certified to meet Ford specifications. Refer to
Lubricant Specifications in this chapter. DOT 3 fluid is recommended.
However, if DOT 3 is not available, DOT 4 fluid can be used.
2 Ensure the correct automatic transmission fluid is used. MERCON
௡ and
MERCON
௡ V are not interchangeable. DO NOT MIX MERCON௡ and
MERCON
௡ V. Refer to the scheduled maintenance information to
determine the correct service interval.
3 Indicates only approximate dry-fill capacity. Some applications may vary
based on cooler size and if equipped with an in-tank cooler. The amount
of transmission fluid and fluid level should be set by the indication on
the dipstick’s normal operating range. Police or Handling Package refill
capacity- 12.8 quarts (12.1L).
4 Add the coolant type originally equipped in your vehicle.
5 Rear axles are considered lubricated for life when the vehicle is used for
normal service. See your scheduled maintenance information for
Severe Duty requirements.
6 Use of synthetic or synthetic blend motor oil is not mandatory. Engine
oil need only meet the requirements of Ford specification
WSS-M2C930-A and the API Certification mark.
7 Service refill capacities are determined by filling the rear axle 1/4 inch
to 9/16 inch (6 mm to 14 mm) below the bottom of the filler hole.
2006 Crown Victoria (cro)
Owners Guide (post-2002-fmt)
USA (fus)
Maintenance and Specifications
254