FORD 2002 Ranger v.1 - Manual (Page 123)

there are no nicks, tears or cuts. Replace if necessary. All safety belt
assemblies, including retractors, buckles, front seat belt buckle
assemblies, buckle support assemblies (slide bar-if equipped), shoulder
belt height adjusters (if equipped), shoulder belt guide on seatback (if
equipped), child safety seat tether bracket assemblies (if equipped),
LATCH child seat tether anchors and lower anchors (if equipped), and
attaching hardware, should be inspected after a collision. Ford Motor
Company recommends that all safety belt assemblies used in vehicles
involved in a collision be replaced. However, if the collision was minor
and a qualified technician finds that the belts do not show damage and
continue to operate properly, they do not need to be replaced. Safety
belt assemblies not in use during a collision should also be inspected and
replaced if either damage or improper operation is noted.
Failure to inspect and if necessary replace the safety belt
assembly under the above conditions could result in severe
personal injuries in the event of a collision.
Refer to Cleaning and maintaining the safety belts in the Cleaning
chapter.
AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
Your vehicle is equipped with a crash sensing and diagnostic module
which records information about the air bag and sensor systems. In the
event of a collision this module may save information related to the
collision including information about the air bag system and impact
severity. This information will assist Ford Motor Company in the
servicing vehicle and helping to better understand real world collisions
and further improve the safety of future vehicles.
OFF
RSM
SET ACC
COAST OFF
ON
SRS
ABS
CHECK
ENGINE
F H H H
! P BRAKE E L SPEED
CONT O/D
OFF
P R N D 2 1 L L
10 MPH
20
50 60 70
30
40 80 90
km/h
0 0 0
10 1
00 1
20 1
0 0 0 0 0 0 40 60 80 100 120 140 160 180 20
OFF
A/C
MAX
A/C
TUNE
SEEK
1 2 3 4 AM-FM
ON OFF
OFF
PASSENGER AIRBAG
Seating and Safety Restraints
123