FORD 2000 Contour - Manual (Page 85)

Seating and safety restraints
85
Safety belt extension assembly
The safety belt may be too short
even when fully extended.
Approximately 20 cm (8 inches)
may be added to the length of the
belt with a safety belt extension
(part number 611C22). Safety belt
extensions are available at no cost
from your dealer.
Only use extensions manufactured
by the same supplier as the safety
belt. Manufacturer identification is
on the label located at the end of
the webbing.
Do not use the extension to change
the fit of the shoulder belt across
the torso.
7. Confirmation of enabling Belt
Minder is provided by flashing the
Saftety belt light four times per
second for three seconds, followed
by three seconds with the Saftety
belt light off, then followed by
flashing the Saftety belt light four
times per second for three seconds
again.
8. Confirmation of disabling Belt
Minder is provided by flashing the
Saftety belt light four times per
second for three seconds.
9. After receiving confirmation, the
deactivation/activation procedure
is complete.
14CSSen 17.6.99 11:00 Uhr Seite 85