NISSAN 2015 370Z Roadster - Quick Reference Guide - Manual (Page 12)

To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi. 10
FIRST DRIVE FEATURES
To activate the autolight system, turn the headlight control switch to the AUTO position
3
then push the ignition switch to ON. To deactivate the autolight system, turn the
headlight control switch to the OFF, position 1
or position 2 .
HIGH BEAM SELECT
Push the headlight control switch forward
4
to
select the high beam function. The blue indicator
light
illuminates in the instrument panel. Pull
the headlight switch back to the original position to
select the low beam. The blue indicator light
will extinguish.
Pull and release the headlight control switch 5
to
flash the headlight high beams on and off.
LANE CHANGE SIGNAL
To signal a lane change, move the lever up or down to the point where the lights
begin flashing.
If the lever is moved back, right after moving up or down, the light will flash 3 times.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
WINDSHIELD WIPER AND WASHER SWITCH
Move the lever to one of the following positions to
operate the windshield wipers:
1
Mist (MIST) - One sweep operation of the
front wipers.
2
Speed Sensing Intermittent (INT) - Move
the lever down to the INT position and then
rotate the control ring
3 to increase or
decrease wiper speed.
4
Low (LO) - Front wipers operate at a
continuous low-speed.
5
High (HI) - Front wipers operate at a
continuous high-speed.
6
Washer - Pull the lever toward you to
activate the washer. The wipers will operate several times.
WIPER DRIP
Once the wiper spray cycle is finished, there will be a short delay. Then the wipers will
sweep one more time to clear off any remaining drips from the windshield.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
3
1
2
4
5
MIST
OFF
INT
LO
HI
6
4 5