Engine block heater (if so equipped) -23 – NISSAN 2008 Altima Hybrid - Owner's Manual User Manual

Page 246

Advertising
background image

Allow more stopping distance under

these conditions. Braking should be

started sooner than on dry pavement.

Allow greater following distances on

slippery roads.

Watch for slippery spots (glare ice).

These may appear on an otherwise

clear road in shaded areas. If a patch of

ice is seen ahead, brake before reach-

ing it. Try not to brake while on the ice,

and

avoid

any

sudden

steering

maneuvers.

Do not use the cruise control on slip-

pery roads.

Snow can trap dangerous exhaust

gases under your vehicle. Keep snow

clear of the exhaust pipe and from

around your vehicle.

ENGINE BLOCK HEATER (if so

equipped)

WARNING

Do not use your engine block heater

with an ungrounded electrical system

or a 2-pronged adapter. You can be se-

riously injured by an electrical shock if

you use an ungrounded connection.

Disconnect and properly store the en-

gine block heater cord before turning

the Hybrid System ON. Damage to the

cord could result in an electrical shock

and can cause serious injury.

Use a heavy-duty 3-wire, 3-pronged ex-

tension cord rated for at least 10 A. Plug

the extension cord into a Ground Fault

Interrupt (GFI) protected, grounded

110-VAC outlet. Failure to use the

proper extension cord or a grounded

outlet can result in a fire or electrical

shock and cause serious personal

injury.

Engine block heaters are available through

NISSAN dealers to assist in cold temperature

starting. The engine block heater should be used

when the outside temperature is 20° F (-7° C) or

lower.
To use the engine block heater:

1. Turn the Hybrid System OFF.
2. Open the hood and unwrap the engine block

heater cord.

3. Plug the engine block heater cord into a

grounded 3-wire, 3-pronged extension

cord.

4. Plug the extension cord into a Ground Fault

Interrupt (GFI) protected, grounded 110-

volt AC (VAC) outlet.

5. The engine block heater must be plugged in

for at least 2 - 4 hours, depending on outside

temperatures, to properly warm the engine

coolant. Use an appropriate timer to turn the

engine block heater on.

6. Before turning the Hybrid System ON, un-

plug and properly store the cord to keep it

away from moving parts.

Starting and driving

5-23

REVIEW COPY—

2008 Altima Hybrid Electric

(ahv)
Owners Manual—USA_English (nna)
05/31/07—debbie

Advertising