Hybrid system, Component location and description – NISSAN 2010 Altima Hybrid - Dismantling Guide User Manual

Page 8

Advertising
background image

Hybrid System


Component Location and Description

Component

Location

Description

1. Electric Air
Conditioning
Compressor

Engine compartment, front
passenger side

Motor driven electric air conditioning compressor supplied
with 245 volts DC.

2. Electric Power
Steering

Engine compartment, on
steering rack

A 42 volt DC assist motor is used for the electric power
steering (EPS) system.

3. EPS DC/DC
Converter

Trunk area, mounted to top
of high voltage battery

Converts 245 volts DC (high voltage) to 42 volts DC (low
voltage) for the EPS.

4. High Voltage
Battery

Trunk area, mounted to
cross member and behind
rear seat

245 volt DC Nickel Metal Hydride (Ni-MH) battery
consisting of 34 low voltage (7.2 volt) modules connected
in series.

5. DC/DC
Converter

Trunk area, under front left
cover of the high voltage
battery

Converts 245 volts DC (high voltage) to 12 volts DC (low
voltage) for charging the 12 volt battery.

6. Service
Disconnect

Trunk area, on the
passenger side of the high
voltage battery

Used to disable the high voltage system.

7. High Voltage
Harnesses

•Trunk area, on high
voltage battery and EPS
DC/DC converter
•Under passenger side
rear seat and floor pan
•Engine compartment, on
rear, driver side and front

Orange colored power cables carry high voltage direct
current (DC) between the high voltage battery, EPS
DC/DC converter, inverter unit, and electric air
conditioning compressor. There are two cables which also
carry 3-phase alternating current (AC) between the
inverter unit and transaxle.
NOTE:
High voltage cables under the vehicle floor are encased in
a black plastic protector.

8. Transaxle

Engine compartment, on
driver side

Contains a traction motor and generator used to drive the
front wheels and recharge the high voltage battery.

9. Inverter Unit

Engine compartment, front
driver side

Changes the 245 volts DC from the high voltage battery to
3-phase 650 volts AC to power the transaxle. The inverter
unit also changes AC electricity from the transaxle to DC
that recharges the high voltage battery.

- 8 -

Advertising