NISSAN 2012 Frontier - Owner's Manual - Manual (Page 176)

Positioning the bed extender
To use the bed extender in the inward position
perform the following:
1. Rotate the bed extender
᭺
1 toward the cab
of the truck.
2. If necessary, remove tethers from the tailgate
latch.
3. Tighten the knobs to secure the extender
into the desired position.
4. Close the tailgate.
5. Place cargo inside the bed extender in the
truck bed.
6. Properly secure the cargo.
To use the bed extender in the outward position
perform the following:
1. Open the tailgate.
2. Rotate the bed extender
᭺
2 away from the
cab of the truck until the extender sits on the
tailgate.
3. Lock the buckles
᭺
3 into the tailgate latch on
both sides.
The bed extender can be adjusted in the outward
position by moving the extender along the rail.
NOTE:
Use care when rotating extender, buckles
may come in contact with the truck bed
railing.
Removing and installing the bed
extender
To remove or install the bed extender perform the
following:
1. Open the tailgate.
2. Rotate the bed extender into a vertical posi-
tion and lift straight up (to remove) or lower
straight down (to install).
To store the bed extender in the front of the truck
when not in use perform the following:
1. Position the sliding brackets past the center
of the wheel well.
2. Re-install the extender into the brackets (see
above).
3. Rotate the extender to the inward position.
4. Push the brackets forward until the extender
comes in contact with the front wall of the
truck box.
LPD0480 LPD0479
Pre-driving checks and adjustments 3-19