NISSAN 2011 JUKE - Owner's Manual - Manual (Page 293)

Black plate (293,1)
Model "F15-D" EDITED: 2010/ 6/ 24
SDI1803
REPLACING
Replace the wiper blades if they are worn.
Before replacing the wiper blades, the wiper
should be in the fully up position to avoid
scratching the engine hood or damaging the
wiper arm. To pull up the wiper arm, see
“WINDSHIELD WIPER AND WASHER
SWITCH” in the “2. Instruments and controls”
section.
1. Lift the wiper arm away from the windshield.
2. Push and hold the release tab
*
A , and
move the wiper blade down the wiper arm
*
1 .
3. Insert the new wiper blade onto the wiper
arm until a click sounds.
4. Rotate the wiper blade so that the dimple is
in the groove.
CAUTION
. After wiper blade replacement, re-
turn the wiper arm to its original
position; otherwise it may be da-
maged when the hood is opened.
. Make sure the wiper blades contact
the glass; otherwise the arm may be
damaged from wind pressure.
SDI1865
Be careful not to clog the washer nozzle
*
A .
This may cause improper windshield washer
operation. If the nozzle is clogged, remove any
objects with a needle or small pin
*
B . Be
careful not to damage the nozzle.
Maintenance and do-it-yourself 8-17