NISSAN 2012 JUKE - Owner's Manual User Manual
Page 205
NOTE:
You must push the
button or the
button within 5 seconds to change
the language.
Current lan-
guage
Push
(TALK/
PHONE SEND)
to select
Push
(MODE/
PHONE END)
to select
English
Spanish
French
Spanish
English
French
French
English
Spanish
5. If you decide not to change the language, do
not push either button. After 5 seconds, the
VR session will end, and the language will
not be changed.
Connecting procedure
NOTE:
The connecting procedure must be per-
formed when the vehicle is stationary. If
the vehicle starts moving during the pro-
cedure, the procedure will be cancelled.
1. Push the
button on the steering wheel.
The system announces the available com-
mands.
2. Say: “Connect Phone”
*
A
. The system
acknowledges the command and an-
nounces the next set of available commands.
3. Say: “Add phone”
*
B
. The system acknowl-
edges the command and asks you to initiate
pairing from the phone handset
*
C
.
The connecting procedure of the cellular
phone varies according to each cellular
phone. See the cellular phone Owner’s
Manual for details. You can also visit www.
nissanusa.com/bluetooth for instructions on
connecting NISSAN recommended cellular
phones.
When prompted for a Passkey code, enter
“1234” from the handset. The Passkey code
“1234” has been assigned by NISSAN and
cannot be changed.
4. The system asks you to say a name for the
phone
*
D
.
If the name is too long or too short, the
system tells you, then prompts you for a
name again.
Also, if more than one phone is connected
and the name sounds too much like a name
already used, the system tells you, then
prompts you for a name again.
Making a call by entering a phone
number
1. Push the
button on steering wheel. A
tone will sound.
2. Say: “Call”
*
A
. The system acknowledges
the command and announces the next set of
available commands.
3. Say: “Phone Number”
*
B
. The system
acknowledges the command and an-
nounces the next set of available commands.
Say: “Special Dialing” to dial more than 10
digits or any special characters.
4. Say the number you wish to call starting with
the area code in single digit format. If the
system has trouble recognizing the correct
phone number, try entering the number in
the following groups: 3-digit area code, 3-
digit prefix and the last 4-digits. For example,
555-121-3354 can be said as “five five five”
as the 1st group, then “one two one” as the
2nd group, and “three three five four” as the
3rd group. For dialing more than 10 digits or
Heater, air conditioner, audio and phone systems
4-55