NISSAN 2014 JUKE - Quick Reference Guide - Manual (Page 11)

9
To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi.
WINDSHIELD WIPER AND WASHER SWITCH
Move the lever to the following positions to operate
the windshield wipers:
01 Mist (MIST) - One sweep operation of the
front wipers.
02
Intermittent (INT) - Wipers operate intermittently.
The intermittent speed can be adjusted by
rotating the control ring 03 to increase or
decrease wiper speed.
04 Low (LO) - Front wipers operate at a continuous
low speed.
05 High (HI) - Front wipers operate at a continuous
high speed.
06
Pull the lever toward you to activate the
front washer. The front wipers will operate
several times.
REAR WINDSHIELD WIPER AND WASHER
07 Intermittent (INT) - Rear wiper operates
intermittently.
08 Low (ON) - Rear wiper operates at a continuous
low speed.
09
Push the lever forward to activate the rear washer.
The rear wiper will operate several times.
WIPER BLADE REPLACEMENT PROCEDURE
The windshield wipers must be in the service position in order to replace the wiper blades.
To move the wiper blades to the service position, follow this procedure:
Turn the ignition switch to the OFF position.
When the ignition switch is in the ON position or within 60 seconds of placing the ignition
switch to the OFF position, push the windshield wiper and washer lever up to the MIST
position
01 two times in less than 0.5 seconds. The windshield wipers will move to the
service position automatically, and the wiper blades can now be replaced.
To move the wiper blades back to the original position:
Pull the windshield wiper and washer lever up for more than 1 second or push the lever
down to operate at any wiper speed.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
01
02
04
05
MIST
OFF
INT
LO
HI
06
09
03
INT
ON
07
08