NISSAN 2011 LEAF - Owner's Manual - Manual (Page 227)

4-6 Ventilators and climate control systems
. When the outside air circulation mode is
on, push and hold the outside air
circulation
button for more than 1.5
seconds.
. When the air recirculation mode is on,
push and hold the air recirculation
button for more than 1.5 seconds.
When setting the automatic control mode,
both indicator lights will blink twice indicat-
ing that the system is in the automatic
control mode.
A visible mist may be seen coming from the
ventilators in hot, humid conditions as the air is
cooled rapidly. This does not indicate a mal-
function.
Heating (A/C off):
1. Push the AUTO button. The AUTO indicator
will be displayed.
2. If the A/C indicator light illuminates, push the
A/C button. The A/C indicator light will turn
off.
3. Push the temperature control ,
button to set the desired temperature. The
temperature range is between 64
8F (188C)
and 90 8F (328C).
. Do not set the temperature lower than
the outside air temperature. Doing so
may prevent the temperature from being
controlled properly.
. If the windows fog up, use dehumidified
heating instead of the A/C off heating.
Dehumidified defrosting/defogging:
1. Push the front defroster button. (The
indicator light will illuminate.)
2. Turn the temperature control ,
button to set the desired temperature.
. To remove moisture or fog on the front
window quickly, set the temperature to
the high temperature and the fan speed
to their maximum level.
. After the windshield is cleared, push the
front defroster button again. (The
indicator light will turn off.)
. When the front defroster button is
pushed, the air conditioner will automa-
tically turn on to defog the windshield.
The outside air circulation mode will be
selected to improve the defogging per-
formance.
Manual operation
The manual mode can be used to control the
heater and air conditioner to your desired
settings.
To turn off the heater and air conditioner, push
the A/C-Heater ON·OFF button.
Fan speed control:
Push “+” of the fan speed control button to
increase the fan speed.
Push “ −” of the fan speed control button to
increase the fan speed.
Push the AUTO button to change the fan speed
to the automatic mode.
Air flow control:
Push the MODE button to change the air flow
mode.
— Air flows from the center and side
ventilators.
— Air flows from the center and side
ventilators and foot outlets.
— Air flows mainly from the foot outlets.
— Air flows from the defroster outlets and
foot outlets.