NISSAN 2014 LEAF - Dismantling Guide - Manual (Page 24)

3-4.6 Alternate Procedure 2 (Remove Service Plug)
• Do not remove the service plug without always wearing appropriate Personal
Protective Equipment (PPE) to help protect the dismantler from serious injury or death
by electrical shock.
• Immediately cover the service plug socket with insulated tape. The Li-ion battery
retains high voltage power even when the service plug is removed. To avoid electric
shock, NEVER touch the terminals inside the socket.
To avoid unintended reinstallation and risk of electrical shock and severe personal injury
or death, the dismantler should carry the service plug on his/her person while work is in
progress.
1. Insert a suitable tool (1) under the RH rear corner of the
access trim cover located on the floor behind the center
console. Pry up (2) and remove.
NOTE:
: Arrow in illustration depicts vehicle front
direction.
2. Remove the 10 mm access cover bolts (1) and remove
the cover (2).
NOTE:
: Arrow in illustration depicts vehicle front
direction.
3. Remove the service plug using the following steps: (1) pull up and release the green lever, (2)
press the locking tab to release and rotate fully upward, (3) pull the service plug completely out of
its socket.
1
2
AAYIA0159ZZ
1
2
AAYIA0158ZZ
DG–24