NISSAN 2012 Maxima - Owner's Manual - Manual (Page 254)

iPod
ா* PLAYER OPERATION WITH
NAVIGATION SYSTEM (if so
equipped)
Connecting iPod
ா
To connect an iPod ா to the vehicle so that the
iPod
ா can be controlled with the audio system
controls and display screen, use the USB jack
located in the center console. Connect the
iPod
ா-specific end of the cable to the iPodா and
the USB end of the cable to the USB jack on the
vehicle
᭺
1 . If your iPod ா supports charging via a
USB connection, its battery will be charged while
connected to the vehicle with the ignition switch
in the ACC or ON position.
While connected to the vehicle, the iPod ா can
only be operated by the vehicle audio controls.
To disconnect the iPod ா from the vehicle, remove
the USB end of the cable from the USB jack on
the vehicle, then remove the cable from the
iPod
ா.
* iPod ா is a trademark of Apple Inc., registered in
the U.S. and other countries.
Compatibility
The following models are compatible:
● iPodா 5th Generation (firmware version
1.2.3 or later)
● iPodா Classic (firmware version 1.1.1 or
later)
● iPodா Touch (firmware version 2.0.0 or
later)*
● iPodா Nano - 1st generation (firmware ver-
sion 1.3.1 or later)
● iPodா Nano - 2nd generation (firmware ver-
sion 1.1.3 or later)
● iPodா Nano - 3rd generation (firmware ver-
sion 1.1.3 or later)
● iPodா Nano - 4th generation (firmware ver-
sion 1.0.4 or later)
● iPodா Nano - 5th generation (firmware ver-
sion 1.0.1 or later)
* Some features of this iPod
ா may not be fully
functional.
Make sure that your iPod ா firmware is updated to
the version indicated above.
LHA2030
Monitor, climate, audio, phone and voice recognition systems 4-93