NISSAN 2011 Murano - Quick Reference Guide - Manual (Page 8)

6
first drive features
rear SeaT eNTrY/eXIT (CrossCabriolet models)
dRiVeR’S Side
To enter the rear seat, push and hold the front end of
the slide switch
01
to slide the driver’s seat forward.
Then push and hold the front end of the reclining
switch
02
until the desired angle is obtained.
To exit the rear seat from the driver’s side, pull the
strap
03
behind the driver’s seat to release the
driver’s seatback. The driver’s seatback will tilt
forward so that you can exit the vehicle.
PASSenGeR’S Side
Push the front passenger’s seatback switch 04
to fold down the front passenger’s seatback and
unlock the seat position.
Manually slide the seat forward to the foremost
position.
enter or exit the back seat.
To slide the front passenger’s seat back into position,
push the bottom half of the seatback
05
until it
locks. next, adjust the seatback by pulling the
seatback lever
06
up. Release the lever to lock
the seatback into position.
for more information, refer to the “Safety – Seats, seat belts and
supplemental restraint system (section 1)” of your Owner’s Manual.
05
06
01
02
03
04