NISSAN 2014 Pathfinder Hybrid - Quick Reference Guide - Manual (Page 28)

26
To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi.
HoMEliNK ® UNivERSAl TRANSCEivER (if so equipped)
The HomeLink system can learn and consolidate the
functions of up to 3 different hand-held transmitters,
operating items such as garage doors, property gates,
outdoor and indoor lights or alarm systems.
To program the HomeLink Universal Transceiver:
• Position the handheld transceiver 1-3 in
(26-76 mm) away from the HomeLink surface,
keeping the HomeLink indicator light in view.
• Press and hold the desired HomeLink button and the handheld transmitter button
simultaneously until the HomeLink indicator light flashes slowly and then rapidly.
• Both buttons may be released when the indicator light flashes rapidly.
To verify the programing is complete, press and hold the HomeLink and observe the
indicator light:
• A solid continuous light indicates the programing is complete and the HomeLink button
will activate your device.
• A blinking light that turns to a solid continuous light after 2 seconds indicates additional
steps are required to complete the programing.
An additional person may make the remaining steps easier. To complete the
programing process:
• At the receiver of the device that you are programing to the HomeLink, press and release
the “learn” or “smart” button (the name may vary by manufacturer but it is usually located
near where the hanging antenna wire is attached to the unit). You have approximately
30 seconds to initiate the following step.
• Press and hold the programmed HomeLink button for 2 seconds and release.
Repeat the previous 2 steps up to 3 times to complete the programming process. HomeLink
should now activate your device.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual, the HomeLink website at
www.homelink.com or call 1-800-355-3515.
HoMEliNK
05
For optimum performance, select the appropriate headphone channel
05
that corresponds to the headrest display being viewed directly in
front of you.
To watch or control videos on the front display make sure the vehicle
is in the P (PARK) position and the parking brake is applied.
To reduce driver distraction, the wireless headphones will not
operate while located in the front seats and movies will not be
shown on the front display while the vehicle is in any drive position.
To access standard DVD controls on the front display while playing a
DVD on the rear display, press the DISC•AUX button on the audio control panel while the
vehicle is in the P (Park) position and the parking brake is applied.
For more information, refer to the “Monitor, climate, audio, phone and voice recognition systems (section 4)” of your
Owner’s Manual.
system guide
1562941_14b_Pathfinder_HEV_QRG_091913.indd 26 9/19/13 11:12 AM