NISSAN 2015 Rogue - Owner's Manual User Manual

Page 99

Advertising
background image

Operation

The MIL will come on in one of two ways:

● MIL on steady — An emission control system

malfunction has been detected. Check the
fuel-filler cap if the LOOSE FUEL CAP
warning appears in the vehicle information
display. If the fuel-filler cap is loose or miss-
ing, tighten or install the cap and continue to
drive the vehicle. The

light should turn

off after a few driving trips. If the

light

does not turn off after a few driving trips,
have the vehicle inspected by a NISSAN
dealer. You do not need to have your vehicle
towed to the dealer.

● MIL blinking — An engine misfire has been

detected which may damage the emission
control system. To reduce or avoid emission
control system damage:

– do not drive at speeds above 45 MPH

(72 km/h).

– avoid hard acceleration or deceleration.

– avoid steep uphill grades.

– if possible, reduce the amount of cargo

being hauled or towed.

The MIL may stop blinking and come on steady.
Have the vehicle inspected by a NISSAN dealer.
You do not need to have your vehicle towed to the
dealer.

CAUTION

Continued vehicle operation without hav-
ing the emission control system checked
and repaired as necessary could lead to
poor driveability, reduced fuel economy,
and possible damage to the emission con-
trol system.

Overdrive OFF indicator light

The overdrive off indicator light illuminates when
the overdrive off mode is selected.

For additional information, refer to “Continuously
Variable Transmission (CVT)” in the “Starting and
driving” section of this manual.

Security indicator light

This light blinks when the ignition switch is
placed in the OFF, LOCK or ACC (if so
equipped) position.

The blinking security indicator light indicates that
the security systems equipped on the vehicle are
operational.

For additional information, refer to “Security sys-
tems” in this section.

Slip indicator light

This indicator will blink when the VDC system is
operating, thus alerting the driver to the fact that
the road surface is slippery and the vehicle is
nearing its traction limits.

You may feel or hear the system working; this is
normal.

The light will blink for a few seconds after the
VDC system stops limiting wheel spin.

The

indicator light also comes on when

you place the ignition switch in the ON position.
The light will turn off after approximately 2 sec-
onds if the system is operational. If the light does
not come on have the system checked by a
NISSAN dealer.

SPORT mode indicator light

This light illuminates and then turns off when the
ignition switch is placed into the ON position, and
when the overdrive off mode off is selected.

For additional information, refer to “Continuously
Variable Transmission (CVT)” in the “Starting and
driving” section of this manual.

2-14

Instruments and controls

Advertising