Cortelco Colleague 2201 - Manual (Page 10)

HOLD BUTTON
1.
To place a call on hold, press the HOLD button and hang up the handset. The HOLD
Indicator will light up and remain lighted until you resume your conversation.
2. To resume your conversation, lift the handset or that of any extension phone on
the same line. The HOLD indicator will go off and your call can continue.
FLASH BUTTON
This telephone provides a line break signal for accessing PABX service or for conve-
nient use of Call Waiting from your local telephone company. If you have Call Waiting
service, you can alternate the Call Waiting function per the following instructions.
1. While having a conversation, another party calls and you hear a tone.
2. Press the FLASH button once and release. The first conversation is placed on hold
and the second call can be answered.
3. Press FLASH button again and release. The first caller can be spoken to again and
the second call is placed on hold.
FLASH SWITCH
The Flash button sends a line interrupt signal to the distant office. The duration of the
interrupt signal can be altered using the FLASH SWITCH for flash settings of 100
milliseconds, 300 milliseconds or 600 milliseconds.
MESSAGE WAITING LAMP
The Message Waiting Lamp will light when a message is waiting at a properly equipped
PABX or telephone central office. This switch allows the phone to be configured for
90V message waiting on T/R (tip/ring, the red/green wires). The lamp also serves as
a visual ring indicator.
DATA PORT
This is a connection which is in parallel with the telephone line. It allows the connection
of a device such as a modem, caller ID, or an answering machine.
POSITIVE LINE DISCONNECT
Positive line disconnect ensures that the hookswitch disconnects the call, therefore;
flash must be used for Call Waiting.
8