Hella FF 1000 User Manual
Page 8
8
Tools required:
• Ruler
• Combination pliers
• Pliers for crimp connectors
(if available)
• 17 mm open end or box wrench
• Drill with 3, 11 and 12 mm dia.
bits
• 3 and 6 mm Allen keys
Insulating tape
1. Bulb
2. Switch
3. Relay
Accessories, see illustration
on page 2:
(not included with kit)
Lamps should not vibrate or extend
above the bonnet and must be
attached symmetrically.
Left figure: Determine mounting
position on flat surface and mark
mounting points.
Drill pilot hole with 3 mm dia. bit
and then bore out to 11 mm.
Protect drilled metal parts with rust
protection paint.
Mounting steps,
see illustration on page 4:
Fig.1: Preliminarily install mount.
Fig. 2: Open housing and install
bulb (Hella part No. 12 V: 8GH 002
089-131 or 24 V: 8GH 002 089-
251). Do not touch bulb with bare
fingers! Use tissue paper or similar.
Fig. 3: Assemble housing. Screw
holder and housing together and
route cable cleanly.
4. Wiring harness with relay,
fuse and switch
5. Two-point mount
6. Adapter mounting set