Hella Micro DE Halogen Fog - Manual (Page 11)

11
1. Install bulb. Do not touch glass
with bare fi ngers (Figs. 1-2).
2. Lay ends of wires to lamps, insert
into lamp housing through rubber
grommet. Push protecting tube over
bared + lead and crimp on cable
terminal (Fig. 3).
3. Connect + lead to bulb connector
and earth lead to retaining spring.
Push the protecting tube completely
over the bare lead connection to the
bulb connector (Fig. 4).
Careful! Danger of short-circuit.
Install relay with connection termi-
nals pointing downwards so that
they are protected against splashing
water (Fig. 5).
Install switch in dashboard: Either
switch supplied with set or special
switch for your vehicle (Fig. 6).
Electrical connection:
Disconnect earth lead (-) from
battery for safety.
Lay and connect wires according
circuit diagram (page 3).
Final installation:
One more tip:
Keep the lenses clean. Dirt can
absorb up to 80 % of the light.
You drive more safely when you
can see and be seen well.
Do you have spare bulbs and
fuses in your vehicle?
If you have any questions or in-
stallation problems: Ring the Hella
service department.
4. Place leads from lamp housing
in the rubber grommet and push
grommet over them up to stop
(drain hole always downward)
(Fig. 5).
5. Screw lamp in correct position
(”Top” upwards, „Hella” visible,
drain hole downwards) in pre-fi tted
holder and tighten hand-tight.
6. Reconnect battery earth lead (-).
Check lights. Align lamp, tighten
screws and secure connecting
leads.
Have the fog lamps adjusted at
a workshop or service station.
Dipped beam headlamps
Dipped beam headlamps and parking lamps
Parking lamps
Main beam headlamps and parking lamps
The symbols mean: Fog lamps illuminate when they are switched on together with:
The table below shows which lights
can be combined with the fog
lamps.
Only properly adjusted lamps
provide optimum illumination wi-
thout dazzling on-coming traffi c.