Jeppesen INDS Data Manager for Windows - Manual (Page 9)

9
2. Click on an Electronic Charts service in the Services area with a status of Available for
Update and drag to the CD in the Update Options area and drop the service to start the
programming process.
3. To cancel this action, drag the service back to the Services area before releasing the
service.
4. The service will download first and then program. You will receive pop-up messages in the
upper right corner with status information.
5. When the programming process has successfully completed, a message will display with a
link to View Alerts and notices. Click on this link to get the latest information on your
services prior to flight. The CD will automatically be ejected once programming has
completed. From this point, you can use the Remote Terminal / DLS process as usual.
Please note that physical media (CD or USB) is only required for Electronic Charts (Blue media)
on aircraft that have NOT enabled the Enhanced Nav option, as the Blue media must be
installed in the DMU during loading process. Nav and Terrain files from the Red/Orange and
Green media can be loaded directly from the PC hard drive or by using the USB option for all
aircraft. Aircraft utilizing the new DMU-3 do not require a CD, but rather should use a USB in
place of the CDs.
*The following options are not valid drop targets in IDM:
• No disc in the CD drive
• CD-R that has been formatted with data on it
• CD-R that has been formatted for UDF ("Like a USB flash drive")
• Blu-ray Disc
• DVD
Terminal Chart Subsetting
An added feature of IDM is the ability to subset your electronic charts coverage by specifying a
smaller geographical area or by runway length before copying to your media. This is helpful if
your avionics system has limited storage capacity. Subsetting affects only the amount of data
copied to the media and loaded into the avionics. You will always have access to the full
coverage.