What to do in emergencies – Dodge 2010 Challenger_SRT - Quick Reference Guide User Manual

Page 51

Advertising
background image

NOTE: If the tire does not inflate to at least 26 psi pressure within 15 minutes, the tire is
too badly damaged. Do not attempt to drive the vehicle further. Call for assistance.

• If the tire inflates to the recommended pressure or is at least 26 psi pressure within

15 minutes, press the Power button

to turn off the TIREFIT kit.

• Remove the Speed Limit sticker from the top of the Sealant Bottle and place the

sticker on the steering wheel.

• Immediately disconnect the Clear Sealant Hose from the valve stem, reinstall the

Yellow Cap on the fitting at the end of the hose, and place the TIREFIT kit in the vehicle
storage location. Quickly proceed to the next step.

CAUTION!

• The metal end fitting from the Power Plug and Cable may get hot after use and

should be handled carefully.

• Failure to reinstall the Yellow Cap on the fitting at the end of the Clear Sealant Hose

can result in sealant contacting your skin, clothing, and the vehicle’s interior. It can
also result in sealant contacting internal TIREFIT kit components which may cause
permanent damage to the kit.

• Immediately after injecting sealant and inflating the tire, drive the vehicle 5 mi (8 km)

or 10 minutes to ensure distribution of the TIREFIT Sealant within the tire. Do not
exceed 55 mph (88 km/h).

• Pull over and repeat Preparations for Jacking or Tire Repair.

• Turn the Mode Select knob to the Air Mode position

.

• Connect the Black Air Pump Hose to the valve stem.

• Check the pressure in the tire by reading the Pressure Gauge.

NOTE: If tire pressure is less than 19 psi, the tire is too badly damaged. Do not attempt
to drive the vehicle further. Call for assistance.

• If the tire pressure is 19 psi or higher, press the Power button

and inflate the tire to

the pressure indicated on the Tire and Loading Information label on the driver's side
door opening.

• Disconnect the TIREFIT kit from the valve stem and then reinstall the valve stem cap.

• Place the TIREFIT kit in its proper storage area in the vehicle.

• Have the tire inspected and repaired or replaced at the earliest opportunity at an

authorized service center.

NOTE: When having the tire serviced, advise the authorized dealer or service center
that the tire has been sealed using the TIREFIT service kit.

• Refer to the Owner's Manual on the DVD for Sealant Bottle and Hose Replacement.

49

WHAT TO DO IN EMERGENCIES

Advertising
This manual is related to the following products: