Electronic throttle control (etc) light, Air bag warning light, Fuel cap/loose gas cap message – Dodge 2011 Challenger_SRT - User Guide User Manual

Page 55: Oil change indicator, What to do in emergencies

Advertising
background image

- Electronic Throttle Control (ETC) Light

• This light informs you of a problem with the Electronic Throttle Control (ETC)

system.

• If a problem is detected, the light will come on while the engine is running. Cycle

the ignition when the vehicle has completely stopped and the shift lever is placed
in the PARK position; the light should turn off.

• If the light remains lit with the engine running, your vehicle will usually be

drivable; however, see an authorized service center immediately. If the light is
flashing when the engine is running, immediate service is required and you may
experience reduced performance, an elevated/rough idle or engine stall and your
vehicle may require towing.

- Air Bag Warning Light

• If the light is not on during starting, stays on, or turns on while driving, have the

vehicle serviced by an authorized service center immediately.

Fuel Cap/Loose Gas Cap Message

• If a “gas cap” message (shown as gASCAP) appears, tighten the gas cap until a

“clicking” sound is heard.

• Press the odometer reset button to turn the message off.

• If the message continues to appear for more than three days after tightening the

gas cap, see your authorized service center.

Oil Change Indicator

Message

• If an “oil change” message (shown as Oil Change Required) appears and a single

chime sounds, it is time for your next required oil change.

Vehicles Equipped With Keyless Enter-N-Go

• Without pressing the brake pedal, push the ENGINE START/STOP button and cycle

the ignition to the ON/RUN position (Do not start the engine.)

• Fully depress the accelerator pedal, slowly, three times within 10 seconds.

• Without pressing the brake pedal, push the ENGINE START/STOP button once to

return the ignition to the OFF/LOCK position.

Vehicles Not Equipped With Keyless Enter-N-Go

• Turn the ignition switch to the ON/RUN position (Do not start the engine.)

• Fully depress the accelerator pedal, slowly, three times within 10 seconds.

• Turn the ignition switch to the OFF/LOCK position.

WHAT TO DO IN EMERGENCIES

53

Advertising
This manual is related to the following products: