Chrysler 2011 300 SRT - Owner Manual - Manual (Page 64)

Inserting Auxiliary Device
Gently insert the Auxiliary device cable into the AUX
Port. If you insert an Auxiliary device with the ignition
ON and the radio ON, the unit will switch to AUX mode
and begin to play when you insert the device cable. The
display will show the track number, and index time in
minutes and seconds. Play will begin at the start of track
1.
Controlling the Auxiliary Device
The control of the auxiliary device (e.g., selecting play-
lists, play, fast forward, etc.) cannot be provided by the
radio; use the device controls instead. Adjust the volume
with the ON/OFF VOLUME rotary knob, or with the
volume of the attached device.
NOTE: The vehicle radio unit is acting as the amplifier
for audio output from the Auxiliary device. Therefore if
the volume control on the Auxiliary device is set too low,
there will be insufficient audio signal for the radio unit to
play the music on the device.
Source
Touch the Source soft-key to select the desired audio
source, Disc, USB/iPod, SD Card, AUX or Bluetooth. This
screen will time out after a few seconds and return to the
main radio screen if no selection is made.
Audio
Refer to Operating Instructions – Radio Mode for adjust-
ing the audio settings.
3
Uconnect Touch™ 8.4 SYSTEM 63