Getting started – Dodge 2013 Journey - User Guide User Manual

Page 19

Advertising
background image

Installing The Top Tether Strap (With Either Lower Anchors Or Vehicle Seat Belt):

• Attach the tether strap to the anchor directly behind the seat where you are placing the

child restraint, being careful to route the tether strap to provide the most direct path
between the anchor and the child restraint, preferably between the head restraint posts
underneath the head restraint.

• Remove all slack and tighten tether strap

according to child restraint manufacturer’s
instructions.

NOTE:
Ensure that the tether strap does not slip
into the opening between the seatbacks as
you remove slack in the strap.

Installing The Child Restraint Using The Vehicle Seat Belts

• To install a child restraint, first, pull enough of the seat belt webbing from the retractor to

route it through the belt path of the child restraint and slide the latch plate into the
buckle.

• Next, extract all the seat belt webbing out of the retractor and then allow the belt to

retract into the retractor. Finally, pull on any excess webbing to tighten the lap portion
around the child restraint. Any seat belt system will loosen with time, so check the belt
occasionally, and pull it tight if necessary.

• Route the tether strap to provide the most direct path for the strap between the anchor

and the child seat, preferably between the head restraint posts underneath the head
restraint.

• Attach the tether strap hook of the child restraint to the tether anchor and remove slack

in the tether strap according to the child restraint manufacturer's instructions.

NOTE:
Ensure that the tether strap does not slip into the opening between the seatbacks as you
remove slack in the strap.

GETTING STARTED

17

Advertising