Uconnect® voice command, Voice command operation, Electronics – Dodge 2014 Avenger - User Guide User Manual

Page 67

Advertising
background image

Transfer Ongoing Call Between Handset And Vehicle

• During a call, press the “Voice Command” button

.

• After the BEEP, say “transfer call.”

Changing The Volume

• Start a dialogue by pressing the “Phone” button

, then adjust the volume during a

normal call.

• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable level

while the Uconnect® system is speaking. Please note the volume setting for Uconnect®
is different than the audio system.

WARNING!

Any voice commanded system should be used only in safe driving conditions follow-
ing applicable laws regarding phone use. Your attention should be focused on safely
operating the vehicle. Failure to do so may result in a collision causing you and others
to be severely injured or killed.

In an emergency, to use Uconnect® Phone, your mobile phone must be:

turned on,

paired to Uconnect® Phone,

and have network coverage.

Uconnect® VOICE COMMAND

Voice Command Operation

• The Uconnect® Voice Command system allows you to control your AM, FM radio, satellite

radio, disc player, HDD, Uconnect® Phone, a memo recorder, and supported portable
media devices.

• When you press the “Voice Command” button

located on the radio faceplate or

steering wheel, you will hear a beep. The beep is your signal to give a command. If you do
not say a command within a few seconds, the system will present you with a list of
options. If you ever want to interrupt the system while it lists options, press the “Voice
Command” button

, listen for the BEEP, and say your command.

NOTE:
Visit http://www.driveuconnect.com/features/voiceCommand/ for more info on which
voice command features apply to your vehicle.

ELECTRONICS

65

Advertising