Resume, Cancel, Operating your vehicle – Dodge 2014 Challenger_SRT - User Guide User Manual

Page 29

Advertising
background image

To Decrease Speed
• When the Electronic Speed Control is set, you can decrease speed by pushing the SET

-

button.

The speed decrement shown is dependant on the speed of U.S. (mph) or Metric (km/h) units:

U.S. Speed (mph)
• Pressing the SET

- button once will result in a 1 mph decrease in set speed. Each

subsequent tap of the button results in a decrease of 1 mph.

• If the button is continually pressed, the set speed will continue to decrease until the

button is released, then the new set speed will be established.

Metric Speed (km/h)
• Pressing the SET

- button once will result in a 2 km/h decrease in set speed. Each

subsequent tap of the button results in a decrease of 2 km/h.

• If the button is continually pressed, the set speed will continue to decrease until the

button is released, then the new set speed will be established.

Resume

• To resume a previously selected set speed in memory, push the RES + button and

release.

Cancel

• Push the CANCEL button, or apply the brakes to cancel the set speed and maintain the

set speed memory.

• Push the ON/OFF button to turn the system off and erase the set speed memory.

WARNING!

• Leaving the Electronic Speed Control system on when not in use is dangerous. You

could accidentally set the system or cause it to go faster than you want. You could
lose control and have a collision. Always leave the Electronic Speed Control system
off when you are not using it.

• Electronic Speed Control can be dangerous where the system cannot maintain a

constant speed. Your vehicle could go too fast for the conditions, and you could lose
control. A collision could be the result. Do not use Electronic Speed Control in heavy
traffic or on roads that are winding, icy, snow-covered or slippery.

OPERATING YOUR VEHICLE

27

Advertising
This manual is related to the following products: