Dodge 2015 Challenger - User Guide - Manual (Page 72)

To Send A Text Message:
1. Push the Uconnect
® Phone Button on the steering wheel.
2. Wait for the beep.
3. Say “Text.”
4. Uconnect
® will prompt you “Say the phone number, or full name and phone type of the
contact you want to send a message to.”
5. Wait for the beep and say a contact that is in your phonebook, or a mobile phone
number that you would like to send the message to.
6. Uconnect ® will prompt you “Please say the message that you would like to send.” (If
you do not hear this prompt, you may not have an active subscription with Uconnect ®
Access).
7. Wait for the beep, and then dictate any message up to 140 characters. If you exceed
140 characters, you will hear the following prompt: “Message was too long; your
message will be truncated.”
8. Uconnect ® will then repeat the message back to you.
9. Uconnect ® will prompt you: “To add to your message, say “Continue”; To delete the
current message and start over, say “Start Over”; to send the current message, say
“Send”; to hear the message again, say “Repeat”.
10. If you are happy with your message and would like to send it, wait for the beep and
say “Send”.
11. Uconnect ® will then say “Sending your message.”
Sample Commands For Voice Text Reply And Voice Texting
Example Command Action
“Text John Smith”
Send a message to specific contact in ad-
dress book
“Text 123 456 7890”
Send 123 456 7890 a message from your
phonebook
“Show messages”
See recent text messages listed by number
on Uconnect ® screen
“Listen to/view (message number four, for
example)”
Hear messages or read it on Uconnect ®
screen
“Reply” Send a voice text reply to a current message
“Forward text/message to “John Smith”
Forward current text to specific contact in
address book
“Forward text/message to “123 456 7890” Forward current text to specific phone num-
ber
E L E C T R O N I C S
70