Dodge 2015 Journey - Uconnect 4.3 Manual - Manual (Page 31)

OVERVIEW
AUX Mode is entered by inserting a AUX device using a
cable with a 3.5 mm audio jack into the AUX port or by
pushing the PLAYER button located left of the display.
Once in Player Mode, press the Source button and select
“AUX.”
Inserting Auxiliary Device
Gently insert the Auxiliary device cable into the AUX
Port. If you connect an Auxiliary device with a 3.5mm
stereo cable into the AUX Port, with the ignition ON and
the radio ON, the unit will switch to AUX mode and
begin to play.
Controlling The Auxiliary Device
The control of the auxiliary device (e.g., selecting play-
lists, play, fast forward, etc.) cannot be provided by the
radio; use the device controls instead. Adjust the volume
with the ON/OFF VOLUME rotary knob, or with the
volume of the attached device.
NOTE:
The vehicle radio unit is acting as the amplifier
for audio output from the Auxiliary device. Therefore if
the volume control on the Auxiliary device is set too low,
there will be insufficient audio signal for the radio unit to
play the music on the device.
SOURCE
Press the source button to select the desired audio source:
“CD,” “AUX” or “USB.” This screen will time out after a
few seconds and return to the main radio screen if no
selection is made.
AUDIO
Refer to Operating Instructions — Radio Mode for ad-
justing the audio settings.
30 AUX MODE