CREATIVE Ipod Xdock - Manual (Page 20)

FAQs 19
Why do other wireless and electronic devices detect interference
when I turn on Xdock?
Your other devices may be detecting signals sent out by Xdock. If you do not
have an X-Fi Wireless Receiver, disable the wireless feature.
i. Press the Power/Standby button to enable Standby mode.
ii. Disconnect the power adapter from your Xdock.
iii. Press and hold the Volume control on your Xdock as you reconnect the
power adapter to your Xdock. The Link LED lights up and then turns off.
To enable the wireless feature, press and hold both the Previous/Rewind
and Next/Fast-forward buttons on your Xdock together for three seconds.
The Link LED lights up again.
Can I change the playback volume using the iPod click wheel?
Your iPod click wheel does not control volume when your player is docked,
even when your iPod appears to be registering volume level changes. When
your iPod is docked, volume can only be controlled using the Volume control
buttons on your remote control or the Volume control on your Xdock.
Can I use the remote control to display photos on my TV?
No. After connecting your Xdock to a TV (see “Connect Your Xdock” on
page 6), press the Play/Pause button on your iPod.
Why is my remote control not responding?
Your remote control’s batteries may have depleted. Replace the batteries.
Will my saved settings be lost when I unplug my Xdock from the
power outlet?
No. If you enable Standby mode before unplugging your Xdock from the
power outlet, your settings will be saved (see “Play music” on page 8).
NOTES This feature is only applicable to iPod models that support TV Out.