Cortelco Caller ID Type II Multi-Feature Telephone 2705 - Manual (Page 8)

8
I
NSTALLATION
DESK MOUNT
1. Select the desired viewing angle and install the desk stand. The desk stand
can be installed in two positions to give a choice of viewing angle.
2. Connect the power adapter. The power adapter connects to the jack marked
DC 9V on the bottom of the phone. Plug the large part of the adapter into the
wall outlet. Use only a 9V DC. 200mA or 300mA, center positive Class 2
adapter.
3. Connect the line cord. The line cord conncects to the jack marked LINE on the
bottom of the phone..
4. Plug the coiled cord into the handset jack, and then plug the other end of the
cord into the base.
5. Place the handset on the base.
WALL MOUNT
1. Remove the desk stand. The unit will then mount directly on a standard wall
telephone jack.
2. Connect the power adapter and the line cord. See Steps 2 and 3 above.
3. Rotate the handset hook into the wall mount position.
4. Plug the coiled cord into the handset, and then plug the other end of the cord
into the base.
5. Place the handset on the base.
ANSWERING MACHINE
1. Connect the LINE jack of the answering machine to the wall telephone jack.
2. Connect the LINE jack of the model 2705 phone unit to the PHONE jack of
the answering machine.
3. Set the answering machine to answer after 2 or more rings.
MESSAGE WAITING LAMP
If your phone is installed behind a Message Waiting enabled PBX, you will need
to set the M/W switch in order to receive Message Waiting indication.
1. Locate the switch on the bottom of the telephone.
2. For 90V PBX Message Waiting Indication, move the switch to the position marked
“90V”. For 24V PBX Message Waiting Indication, move the switch to the posi
tion marked “24V”. If connecting directly to telephone lines, move the switch to
the center “OFF” position.