COBY TF-TV1913 - Manual (Page 5)

TV Function
TV Function
Preparations
1. Connect the antenna to the antenna jack on the unit side panel.
2. Connect the power supply cord. Press POWER to turn on the the player.
3. Press MODE on the remote to select TV.
4. Press CH+/- buttons to skip channels or press numeric buttons to input channel directly.
Setup Menu
Various features can be preset through the TV setup menu.
TV setup menu consists of six menus. They are Picture Menu, Audio Menu, Time Menu, Option Menu,
Lock Menu as well as Channel Menu.
1. Press MENU to show the menu window.
2. Press the left/right button to select the menu, press OK to enter the menu.
Working with menu
While working with the menu,
1. Press the up/down direction button to select the item.
2. Press the left/right direction button to adjust
3. Press MENU to exit.
6
R
Cable Connections
5
Figure. Cable connections
Antenna Connection
Connect TV RF sources to the antenna port. TV RF signals include: receiving antenna/CATV net. You
can use 75 coaxial cable to connect outdoor antenna.
AV Signal Input
You can adopt any of the three methrods below to input the AV signal.
Defined by the image definition, component input mode ranks first among the three and the S-Video
input mode works much better than the RCA mode does.
Component - Connect the YCbCr port by the component cable (not supplied) to input the video signal.
Connect the “L” “R” port to input the audio signal by the white&red plug of the RCA cable.
S-Video - Connect the “S-Video” port by the S-Video cable(not supplied) to input the video signal.
Connect the “L” “R” port to input the audio signal by the white&red plug of the RCA cable.
RCA - - Connect the “Video” port to input the video signal by the yellow plug of the RCA cable.
Connect the “L” “R” port to input the audio signal by the white&red plug of the RCA cable.
VGA Connection (PC Connection)
When used as the computer screen, connect the VGA port by the 15-pin D-SUB signal cable and the
PC Audio In port by the audio cable.
Power Connection
Insert one end of the power cord to the power jack on the unit and the other end to the wall outlet with
AC100-240V. If the unit will not be used for long period of time, please disconnect the power.
Set the unit to the relative input mode
to enable the signal pass.
AC100-240V
Outlet
NOTE: 1. Be sure to have all necessary connections properly
done before connect the power supply.
2. When input the AV signal, refer to the manual of the
external sources as well.
External AV Source