Cub Cadet 421R - Manual (Page 7)

7
SECTION 3: KNOW YOUR SNOW THROWER
Be familiar with all the controls and their proper operation. Know how to stop the machine and disengage
them quickly.
• Compare Figure 9 with the controls on your snow thrower before starting the machine or trying to operate it.
Figure 9
Choke Lever
Place choke lever in “ON” position to start a cold
engine.
Primer Button
Used to inject fuel directly into the carburetor to insure
fast starts in cold weather. Follow engine manual to
prime engine.
Ignition Key
Used to start engine. Put key in “ON” position to start.
Starter Handle
Used to manually start the engine.
Spark Plug Cover
Spark plug located under the cover.
Auger Control Handle
Located on the upper handle, the auger control handle
is used to engage and disengage the augers. The snow
thrower is designed to be propelled by the rotation of
the augers. Pull the control handle back against the
upper handle to engage the augers; release to
disengage.
Chute Crank
Located on right side of dash panel, the chute crank
determines the direction that snow will be discharged.
Turn clockwise to discharge snow to the left; turn
counterclockwise to discharge to the right.
Discharge Chute
The angle of the discharge chute controls the distance
that the snow is thrown. Tilt the discharge chute up for
greater distance; tilt down for less distance. Loosen the
hand knob on the side of the discharge chute to adjust.
Tilt the chute to the desired position, and tighten the
knob.
Stopping Engine
• Turn ignition key to OFF position and remove it
from the snow thrower.
Upper
Auger Control
Chute Crank
Auger
Discharge
Shave
Plate
Handle
Chute
Handle
Ignition
Key
Choke Lever
On Off
Starter
Handle
Spark
Plug
Cover
Button
Primer