30" gas slide-in range installation instructions – FRIGIDAIRE FGGS3065PF User Manual

Page 12

Advertising
background image

12

30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS

(Models with Sealed Top Burners)

Air Shutter

Air Shutter

Waist-High Burner

Lower Oven Bottom

(removable)

Lower

Oven Baffle

(removable)

Figure 16

11.5

Operation of Oven Burners and Oven

Adjustments

11.5.1 Electric Ignition Burners

Operation of electric igniters should be checked after

range and supply line connectors have been carefully

checked for leaks, and range has been connected to

electric power.
The oven burner is equipped with an electric control

system as well as an electric oven burner igniter. If your

model is equipped with a waist-high broil burner igniter,

it will also have an electric burner igniter. These control

systems require no adjustment. When the oven is set to

operate, current will flow to the igniter. It will "glow" similar

to a light bulb. When the igniter has reached a temperature

sufficient to ignite gas, the electrically controlled oven valve

will open and flame will appear at the oven burner. There

is a time lapse from 30 to 60 seconds after thermostat is

turned ON before the flame appears at the oven burner.

When the oven reaches the display setting, the glowing

igniter will go off. The burner flame will go "out" in 20 to 30

seconds after igniter goes "OFF". To maintain any given

oven temperature, this cycle will continue as long as the

display is set to operate.

After removing all packing materials and literature from

the oven:

a) Set the oven to BAKE at 300°F. See Use & Care

Guide for operating instructions.

b) Within 60 seconds the oven burner should ignite.

Check for proper flame, and allow the burner to cycle

once. Reset controls to off.

c) If your model is equipped with a high-waist broiler,

set oven to broil. See Use & Care Guide for operating

instructions.

d) Within 60 seconds the broil burner should ignite.

Check for proper flame. Reset controls to off.

11.5.2 Air Shutter-Oven Burner

The approximate oven burner flame length is 1 inch

(distinct inner cone of blue flame).
To determine if the oven burner flame is proper, remove

the oven bottom and burner baffle and set the oven to

bake at 300°F.
To remove the oven bottom, remove oven hold down

screws at rear of oven bottom. Pull up at rear, disengage

front of oven bottom from oven front frame, and pull the

When All Hookups are Complete

Make sure all controls are left in the OFF position.
Make sure the flow of combustion and ventilation air to

the range is unobstructed.

Model and Serial Number Location

The serial plate is located on the oven front frame

behind the oven door (some models) or on the drawer

side frame (some models).
When ordering parts for or making inquiries about your

range, always be sure to include the model and serial

numbers and a lot number or letter from the serial plate

on your range.
Your serial plate also tells you the rating of the burners,

the type of fuel and the pressure the range was

adjusted for when it left the factory.

Before You Call for Service

Read the Before You Call Checklist and operating

instructions in your Use and Care Guide. It may save

you time and expense. The list includes common

occurrences that are not the result of defective

workmanship or materials in this appliance.
Refer to your Use & Care Guide for service phone

numbers.

oven bottom out of the oven. Remove burner baffle so

that burner flame can be observed.
If the flame is yellow, increase air shutter opening size

(see "2" in Figure 17). If the entire flame is blue, reduce

the air shutter opening size.
To adjust frame loosen lock screw (see "3" in Figure 17),

reposition air shutter, and tighten lock screw. Replace

oven bottom.

11.5.3 Air Shutter-Broil Burner

The approximate flame length of the burner is 1 inch

(distinct inner cone of blue flame). To determine if the

broil burner flame is proper, set the oven to broil. If flame

is yellow, increase air shutter opening size (see "2" in

Figure 17). If the entire flame is blue, reduce the air

shutter opening size. To adjust, loosen lock screw (see

"3" in Figure 17), reposition air shutter, and tighten lock

screw.

Oven Burner Tube

Orifice Hood

Lock Screw

Air Shutter

Figure 17

2

1

3

Advertising
This manual is related to the following products: