FRIGIDAIRE FFED3025LW - Manual (Page 8)

8
30" ELECTRIC DROP-IN RANGE INSTALLATION INSTRUCTIONS
Figure 4
Figure 5
Figure 6
4
Anti-tip Bracket installation
A. Preferred Anti-tip installation (All models)
1. The range is equipped with an anti-tip bracket
attached to the back of the range with two screws.
If countertop thickness is greater than 1/2" (1.3cm),
relocate anti-tip bracket to the lower position 1/4"
(6.4 mm) below (see figure 4).
2. Anti-slide brackets Installation (Figure 5):
A. Place the range so that it is about 6" out of the
cabinet.
B. Insert from below the shoulder screws in the
bottom bracket (one on each side)
C. Slide the range into its final position.
D. Position the "L" bracket against the side of the
cabinet so that it is retained by the shoulder
screws, hold bracket and mark the holes on the
inside of the cabinet. Drill pilot holes into cabinet
where you just marked (Caution should be taken
to avoid drilling through the opposite side of the
cabinet). Attach the "L" bracket to the cabinet
with the screws provided (don't forget to insert
the shoulder screw into the bracket).
E. Repeat steps D on the other side.
3. Install the decorative lower trim under the door
using the screws provided with the range.
B. Alternate Anti tip installation (All models)
1. The range is equipped with two anti-tip "L" brackets
located on each side of the range with two screws
(see figure 6).
ANTI-TIP BRACKET
AT REAR OF RANGE
ANTI-TIP "L" BRACKET
ON EACH SIDE OF
RANGE