FRIGIDAIRE FFHT1831QE - Manual (Page 6)

6
WARNING
The anti-tip device must be
installed according to the
instructions in your Use &
Care Manual. Failure to do
so will result in injury.
WARNING
When reversing the door swing:
You MUST move the anti-tip bracket to align
with the hinges of the door. Failure to do so
will result in injury.

NOTE
Raise the front of the refrigerator enough so
the doors close freely when opened halfway.
The refrigerator should slope ¼ inch to
½ inch from front-to-back. Then level the
refrigerator from side-to-side.
To level the cabinet using the front
rollers:
1 Remove the toe grille.
2 Use a flat-blade screwdriver or ⅜ inch
socket wrench to raise or lower the front
rollers (Figure 2). Do not raise the cabinet
more than 9 /
16
inch.
Figure 4 (some models)
Lower
Anti-tip
Bracket
Raise
9/16"
Max
Figure 3
9/16"
Max
Raise
Figure 2
or
3 Use adjustable wrench to adjust leveling
screws. Lower the leveling screws on each
side clockwise until they contact the floor
(Figure 3). Do not raise the cabinet more
than 9 /
16
inch.
4 Some models are equipped with an anti-
tip bracket (Figure 4). Lower it clockwise
until it contacts the floor.
some models
INSTALLATION