FRIGIDAIRE FGGF301DNW - Manual (Page 8)

8
30" GAS RANGE INSTALLATION INSTRUCTIONS
Figure 11
A. Push in and turn each control to LITE until burner
ignites.
B. Push in and quickly turn knob to LOWEST POSITION.
C. If burner goes out, Reset control to OFF.
D. Remove the surface burner control knob.
E. Insert a thin-bladed screwdriver into the hollow valve
stem and engage the slotted screw inside. Flame size
can be increased or decreased with the turn of the
screw. Turn counterclockwise to increase flame size.
Turn clockwise to decrease flame size.
7 Electric Ignition Surface Burners
Operation of electric igniters should be checked after
range and supply line connectors have been carefully
checked for leaks, and range has been connected to
electric power. To check for proper lighting:
A. Push in and turn a surface burner knob to the LITE
position. You will hear the igniter sparking.
B. The surface burner should light when gas is
available to the top burner. Each burner should light
within four (4) seconds after air has been purged
from supply lines. Visually check that burner has lit.
C. Once the burner lights, the control knob should be
rotated out of the LITE position.
D. There are separate ignition devices for each burner.
Try each knob separately until all burner valves have
been checked.
8 Adjust the "LOW" Setting of Surface
Burner Valves
Burner Flame Size
Main
Top
Adjust flame until you can quickly turn knob from LITE to
LOWEST POSITION without extinguishing the flame. Flame
should be as small as possible without going out.
Note: Air mixture adjustment is not required on surface
burners.
9 Operation of Oven Burners and Oven
Adjustments
Electric Ignition Burners
Operation of electric igniters should be checked after
range and supply line connectors have been carefully
checked for leaks, and range has been connected to
electric power.
The oven burner is equipped with an electric control
system as well as electric oven and broil burner igniters.
These control systems require no adjustment. When the
oven is set to operate, current will flow to the igniter. It will
"glow" similar to a light bulb. When the igniter has reached
a temperature sufficient to ignite gas, the electrically
controlled oven valve will open and flame will appear at the
oven burner. There is a time lapse from 30 to 60 seconds
after thermostat is turned ON before the flame appears
at the oven burner. When the oven reaches the display
setting, the glowing igniter will go off. The burner flame
will go "out" in 20 to 30 seconds after igniter goes "OFF".
To maintain any given oven temperature, this cycle will
continue as long as the display is set to operate.
After removing all packing materials and literature from
the oven:
A. Set the lower oven to BAKE at 300°F. See Use & Care
Guide for operating instructions.
B. Within 60 seconds the oven burner should ignite.
Check for proper flame, and allow the burners to
cycle once. Reset controls to OFF.
C. Repeat A and B with the upper oven.
D. Set the upper oven to broil. See Use and Care Guide
for operating instructions.
E. Within 60 seconds the broil burner should ignite.
Check for proper flame. Reset controls to off.