FRIGIDAIRE FGEF306TMB - Manual (Page 16)

16
SETTING OVEN CONTROLS
Í NOTE
The surface elements cannot be activated when the
Lockout feature is active (see the section: The electronic
surface element control (ESEC)).
SETTING LOCKOUT FEATURE
The pad controls the Lockout feature. The Lockout
feature automatically locks the oven doors, the control
panel and the cooktop. It does not disable the Minute
Timer or the interior oven lights.
To activate the Lockout feature
1. Press and hold for 3 seconds.
2. After 3 seconds “Loc” and “Control” will appear, a
beep will sound, “UPPER”, “LOWER” and “DOOR” will
fl ash in the display. Once the oven door is locked the
“DOOR” will stop fl ashing and remain on along with
the “Loc”, “Control” and the icon will appear.
To reactivate normal operation:
1. Press and hold for 3 seconds. A beep will sound.
The “UPPER”, “LOWER” and “DOOR” will fl ash in the
display until the oven door has completely unlocked and
the icon will disappear.
2. The unit is again fully operational.
SETTING TIMER
The TIMER ON.OFF pad controls the Timer feature. The
Timer serves as an extra timer in the kitchen that will
beep when the set time has run out. It does not start or
stop cooking. The Timer feature can be used during any
of the other oven control functions. Refer to “Minimum
and Maximum Control Pad Settings” for time amount
settings.
To set the Timer (example for 5 minutes)
1. Press
TIMER ON.OFF. “-- --” will appear in the
display.
2. Use the number pads to set the desired time in the
display; press 5.
3. Press START. The time will begin to count down with
“5:00” in the display.
Note: If START is not pressed the timer will return to the
time of day after 25 seconds.
4. When the set time has run out, “End” will show in
the display. The clock will sound with 3 beeps every 5
seconds until TIMER ON.OFF is pressed.
To cancel the Timer before the set time has run
out
1. Press TIMER ON.OFF. The display will return to the
time of day.
SETTING ADD 1 MINUTE FEATURE
The ADD 1 MINUTE pad is used to set the Add 1 Minute
feature. When the ADD 1 MINUTE pad is pressed, 1
minute is added to the Timer feature if this feature is
already active. If the Timer feature is not active and
the ADD 1 MINUTE pad is pressed, the Timer feature
will become active and will begin counting down from 1
minute.
SETTING SILENT CONTROL OPERATION
The DELAY START and SELF CLEAN pads control
the Silent Control operation feature. The Silent Control
operation feature allows the oven control to be operated
without sounds or beeps whenever necessary. If desired
the control can be programmed for silent operation and
later returned to operating with all the normal sounds
and beeps.
To change control from normal sound operation to
silent control operation
1. To tell if your range is set for normal or silent
operation press and hold DELAY START. “-- --” will
appear and “DELAY” will fl ash in the display. After
6 seconds “bEEP On” or “bEEP OFF” will appear in
the display.
2. Press SELF CLEAN to switch between normal sound
operation and silent operation mode. The display will
show either “bEEP On” or “bEEP OFF”.
Note: If “bEEP On” appears, the control will operate with
normal sounds and beeps. If “bEEP OFF” appears, the
control is in the silent operation mode.
3. Press
START to accept the change or press CANCEL
to reject the change.
Note: The control will always beep at the end of a minute
timer and will beep when a set temperature has been
reached, even if the control is set to silent operation.