Compaq Memory Channel Hub User Manual
Page 18
Installation
2–6 DIGITAL 2T-CCMHA-CB Central Office Memory Channel Hub Installation/Service Guide
2.4.2 Attaching the Slide Assemblies to the Cabinet Rails
The following sections contain the procedures for attaching the right and left slide
assembles to the cabinet rails.
2.4.2.1 Attaching the Right Slide Assembly to the Cabinet Rails
To attach the right slide assembly to the cabinet rails, refer to Figure 2-2 and proceed as
follows:
1. Determine the proper mounting holes for the right slide brackets. The proper mounting
holes are the 1st, 2nd, and 3rd holes of the installation area (see Figure 2-1).
2. Locate the right slide assembly.
3. Place the right front slide bracket on the inside of the right front rail and align the
three slide bracket holes and with the 1st, 2nd, and 3rd holes of the installation area on
the right front rail.
4. Install two 10-32 truss-head screws
in the 1st and 3rd holes of the installation area
to secure the right front slide bracket to the right front rail, but do not tighten.
5. Install a 10-32 standoff
in the 2nd hole of the installation area on the right front rail.
Tighten this standoff.
6. Place the right rear slide bracket on the inside of the right rear rail and align the three
slide bracket holes and with the 1st, 2nd, and 3rd holes of the installation area on the
right rear rail.
7. Install three 10-32 truss-head screws
in the 1st, 2nd, and 3rd, holes of the
installation area to secure the right rear slide bracket to the right rear rail, but do not
tighten.
8. Tighten the two 8-32 screws and nuts that secure the right rear slide bracket to the
right slide assembly.
9. Securely tighten all five 10-32 truss-head screws that secure the right slide assembly
to the right front and rear cabinet rails.
10. Install a 10-32 standoff
in 14th hole of the installation area on the right front rail
and secure it in place with a 10-32 nut.