Important – FRIGIDAIRE FGDS3065KW User Manual

Page 2

Advertising
background image

2

30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS

(Models with an Electric Oven and a Gas Cooktop)

NOTE:

1. Do not pinch the power supply cord or the

flexible gas conduit between the range and
the wall.

2. Do not seal the range to the side cabinets.
3. 24" (61 cm) minimum clearance between

the cooktop and the bottom of the cabinet
when the bottom of wood or metal cabinet is
protected by not less than ¼" (0.64 cm) flame
retardant millboard covered with not less than
No. 28 MSG sheet metal, 0.015"(0.4 mm)
stainless steel, 0.024"(0.6 mm) aluminum, or
0.020" (0.5 mm) copper.

30" (76.2 cm) minimum clearance when the

cabinet is unprotected.

4. For cutouts below 22 7/8"(58.1 cm), appliance

will slightly show out of the cabinet.

5. Allow at least 19 ¼" (48.9 cm) clearance for

door depth when it is open.

21¾”

(55.25 cm)

D

C

A

B

Door

Open

Side Panel

1 1/8"

(2.86 cm)

FRONT OF

CABINET

F

Ref.

22 7/8"(58.1 cm) min.

23 1/4"(59.05 cm) max.

(see Note 4)

*** IMPORTANT:

To avoid cooktop breakage for cutout width (E dimension) of more

than 30 1/16" (76,4 cm), make sure the appliance is centered in the counter opening

while pushing into it. Raise leveling legs at a higher position than the cabinet height
(see page 3), insert the appliance in the counter and then level.

Make sure the unit

is supported by the leveling legs and NOT by the cooktop itself.

IMPORTANT:

Cabinet and countertop

width should match the cutout width.

E

E

A. HEIGHT

(Under Cooktop)

B. WIDTH

C. COOKTOP

WIDTH

D. TOTAL DEPTH TO

FRONT OF RANGE

E. CUTOUT WIDTH***

(Countertop

and cabinet)

F. CUTOUT

DEPTH

G. HEIGHT

OF COUNTERTOP

35 7/8" (91,1 cm)

36 5/8" (93 cm)

30" (76,2 cm)

31 1/2"

(80 cm)

28 5/16" (71,9 cm)

30±1/16"

(76,2±0,15 cm)

21 3/4" (55,2 cm) Min.

22 1/8" (56,2 cm) Max

24" (61 cm) Min. with

backguard

35 7/8" (91,1 cm) Min.

36 5/8" (93 cm) Max.

Advertising
This manual is related to the following products: